Compute active and reactive powers of voltage-current pair at fundamental frequency
The Power block computes the active power (P), in watts, and the reactive power (Q), in vars, of a voltage-current pair at fundamental frequency. To perform this computation, the block first determines the fundamental values (magnitude and phase) of the two input signals V & I. The following P and Q are then calculated:
As this block uses a running average window, one cycle of simulation must complete before the outputs give the correct value. For the first cycle of simulation, the outputs are held constant using the values specified by the Voltage initial input and Current initial input parameters.
Specify the fundamental frequency, in hertz, of the input signals.
Specify the voltage initial magnitude and phase to set a constant output for the first cycle of simulation.
Specify the current initial magnitude and phase to set a constant output for the first cycle of simulation.
Specify the sample time of the block, in seconds. Set to 0 to implement a continuous block.
|Sample Time||Specified in the Sample Time parameter|
Continuous if Sample Time = 0
|Scalar Expansion||Yes, of the parameters|
The model sample time is parameterized by the Ts variable set to a default value of 50e-6 s. Set Ts to 0 in the command window to simulate the model in continuous mode.